13
Authentication unit (Biometric type AU-101)
13-36 bizhub 501/421/361 (Version 2)
13.5 Care of Authentication unit (Biometric type) AU-101
2
Reminder
Before cleaning this device, disconnect it from the multifunctional product. If a force is applied to the
USB port, it may be damaged.
When cleaning this device, do not allow water to enter the device, otherwise the system may be
damaged.
Never use organic solvents, such as benzine or alcohol, to clean this device, otherwise it may be
damaged.
2
Note
When disconnecting or connecting this device, turn off the multifunctional product with the main power
switch, and then wait at least 10 seconds before turning it on again. The machine may not operate
correctly if it is turned on immediately after being turned off.
Hold the plug when plugging and unplugging the USB cable, otherwise the cable may be damaged.
Care of the housing
Frequency: Once a month, or when it is dirty
Wipe the housing with a soft, dry cloth. If the housing cannot be cleaned by wiping it, wash it with a cloth
dampened with a mild detergent and wrung out well. After the housing is cleaned, rinse the cloth and wring
it out well before wiping off the detergent.
Care of the scanner
Frequency: Once a month, or when it is dirty or covered with fingerprints
Care of the scanner Frequency: Once a month, or when it is dirty or covered with fingerprints Clean the
scanner with a soft cloth used to wipe eyeglass lenses. If it is extremely dirty, clean it with an eyeglass lens
cleaner.
To Next Page
Loading...
Need help?
General
