1
2
3
4
5
6
7
8
9
10
11
12
107
5�3 Cleaning Parts
This section describes the parts that require periodic cleaning.
5�3�1
Cleaning Film Ejection Tray
The lm ejection tray tends to be dusty. Dust could damage the printed lm. Wipe o the dust with dry
cloth once every three months.
5�3�2
Cleaning Supply Tray
Keep the inside of the supply tray clean. Wipe o the dust with dry cloth or vacuum the dust once every
three months.
When wiping with cloth, be careful not to get injured by a protrusion
in the supply tray�
Film ejection port
To Next Page
Loading...
