1
2
3
4
5
6
7
8
9
10
11
12
15
1�4 Safety Precautions
Read all safety precautions thoroughly before using the product.
Be sure to observe the safety precautions described in this section.
1�4�1
Precautions when Installing
WARNING
• The product must not be modified�
Modifications to the product could cause failure, electrical shock or fire.
• Have the product installed by the distributor where you purchased the product or
Konica Minolta technical representatives.
Improper installation performed by yourself could cause an electric shock or fire.
• Ground�
Do not ground to gas line, water supply pipe, lightening rod, or telephone.
To avoid the risk of electric shock, this equipment must only be connected to a supply mains with
protective earth.
• Electrical work (including grounding and communication cable wiring work) must be per-
formed in compliance with applicable technical standards for electrical installation�
Improper work could cause an electric shock or failure.
• Use power supply with sufficient capacity to meet power requirements and specifications�
If you use power supply that does not meet specifications or that does not supply sufficient cur-
rent, it could cause overheating of electrical components or fire.
1�4�2
Precautions for Relocating, Storing Temporarily, and Repairing
CAUTION
• Use a 15A outlet independently�
Do not share the outlet with other equipment. Otherwise it can cause the circuit breaker to trip.
•
If unusual noise, odor, or smoke coming from this product is detected, immediately stop
operation down and unplug it. Then, contact the distributor where you purchased the product or
Konica Minolta technical representatives.
If you continue to operate it with abnormal condition left as it is, it could cause failure, electric shocks, or fire.
•
For handling of errors not described in this document, contact Konica Minolta technical
representatives.
Improper repair made by yourself could cause an electric shock or fire.
•
Before relocating, temporarily storing or reinstalling the product, the distributor where you
purchased the product or Konica Minolta technical representatives.
Improper relocation and reinstallation performed by yourself could cause electrical shocks or fire.
• Do not remove the lithium batteries.
Lithium batteries may explode if exposed to fire or water.
To Next Page
Loading...
