34
2�3 Structure
The structure of DRYPRO 873 is shown below. Film is fed in the order from (1) ((2), (3)) to (11) during
the print process.
(11) Film ejection port
(8) Deodorant Filter
(1) Supply tray 1
(6) Sub-scanning unit
(7) Exposure unit
(5) Position regulation unit
(2) Supply tray 2
(3) Supply tray 3
(10) Cooling/Transport unit
(9) Heat process unit
(4) Elevating transportation
unit
(4) Elevating transportation
unit
Num-
ber
Name Function Refer to
(1)
Supply tray 1 Picks up a sheet of film in the supply tray 1 and
transports to the position regulation unit.
―
(2)
Supply tray 2 Picks up a sheet of film in the supply tray 2 and
transports to the elevating transportation unit.
―
(3)
Supply tray 3 Picks up a sheet of film in the expansion tray and
transports it to the position regulation unit.
2.2.6 Expansion tray (optional) (page 32)
2.2.7 Mammography media expan-
sion tray (optional) (page 33)
(4)
Elevating trans-
portation unit
Transport film transported from the supply tray 2
and 3 to the position regulation unit.
―
(5) Position regula-
tion unit
Regulates the horizontal position of the film trans-
ported from the supply unit to the exposure unit.
―
(6)
Sub-scanning unit Transports film transported from the position regula-
tion unit to the exposure unit.
―
(7)
Exposure unit
Scans laser beam in synchronization with the film
transportation and writes images on the film.
―
(8)
Deodorant Filter
Removes odors emitted during heat process. Peri-
odic change is needed.
5.4 Changing Deodorant Filter (page
109)
(9)
Heat process unit
Develops the exposed film by heating. ―
(10)
Cooling/Transport unit
Cools and discharges heat developed film. ―
(11)
Film ejection port
Printed films are ejected. ―
To Next Page
Loading...
Need help?
General
