64
Maintenance Mode
6
After cleaning the cleaning roller, close the cover to complete the cleaning.
7
When the cover is closed, the following message appears, and the main
unit begins drying the cleaning roller� Drying takes about three minutes to
complete�
8
When operations have finished, the maintenance menu appears, and roller
cleaning
is completed�
3.6.8
System Reset
This performs a cold start (restart) of the main unit. The connected PC also restarts. When system
reset is performed, all queued print data is deleted.
1
Enable maintenance mode.
“3.6.1 Enabling and Using Maintenance Mode” (page 54)
2
Use the [Test print] and [Calibration] buttons to move the cursor to the [Sys-
tem Reset] icon . Press the [Service/Enter] button to select the item.
3
The following message appears in the display window�
4
Use the [Test print] and [Calibration] buttons to move the cursor to [YES]
or [NO].
5
Press the [Service/Enter] button to select the item.
Select [YES] to perform a system reset.
Select [NO] to return to the maintenance menu.
6
Press the [Reset/Cancel] button to return to the maintenance menu.
To Next Page
Loading...
Need help?
General
