38
Starting and Shutting Down
When the standby mode is canceled, DRYPRO 873 is started, and the following ap-
pears in the display window.
•
You cannot print during warm-up.
• You can make settings during warm-up.
•
It takes about 3 minutes for the machine to get ready for print. However, it
varies according to the season and the ambient room temperature.
3�1�3
How to Shut Down
To shut down DRYPRO 873, perform the following steps.
Check the following points before performing a shutdown operation�
• If the message "Printing..." does not appear in the display window.
If the machine is not shut down after the expiration of three min-
utes or more following a shutdown operation, press and hold the
operation switch again for 10 seconds or longer� The machine will
be shut down. Then, turn OFF the power supply circuit breaker,
and turn it ON again.
After the shutdown operation completes, the deodorizing fan and
supply cooling fan continue to operate for about one hour�
When performing the shutdown operation, do not switch the pow
-
er supply circuit breaker OFF immediately. (To turn the power sup-
ply circuit breaker o, wait approximately 1 hour after completing
the shutdown operation before switching the breaker o.)
To Next Page
Loading...
Need help?
General
