82
4�4 How to Clear Errors
This section describes how to clear (reset) errors.
When the message “Film empty”, “Film jam”, or “Filter exchange” is displayed, perform necessary
operation.
“3.3 Loading Films” (page 44)
“4.5 How to Clear a Film Jam” (page 85)
“5.4 Changing Deodorant Filter” (page 109)
If the error persists even after coping with the error as mentioned below, contact Konica Minolta techni-
cal representatives. To ensure prompt and eective support, please provide the error code and error
message displayed in the display window as well as a description of the problem.
4�4�1
Reset from Operation Panel
When an error occurs in DRYPRO 873, the error message appears in the message display window on
the operation panel. In addition, the [Reset/Cancel] lamp lights up and the red status lamp illuminates.
After handling the error according to the error message, reset the error display.
Error Message Starting with “E” (other than film jam, cover, and tray)
When the [Reset/Cancel] button is pressed, the message "Operating Please wait" is displayed.
Once the error has been successfully reset, "Ready" appears in the message display window and the
machine is ready to print.
Error Message Starting with “E”(cover and tray errors)
If a cover opens during operation or a tray opens other than when loading lm, the error is reset auto-
matically, and the message "Operating Please wait" is displayed once the cover or the tray is closed.
Once the error has been successfully reset, "Ready" appears in the message display window and the
machine is ready to print.
To Next Page
Loading...
Need help?
General
