KTM 1290 SUPER DUKE R 2021 User Manual

6 CONTROLS
18
6.9 Cruise control buttons
S03881-14
The cruise control buttons
1
,
2
and
3
of the are located on
the left side of the combination switch.
Possible states
• Cruise control system button in the basic position.
• The +RES button is pressed briefly. – The last saved speed
is reapplied. Every subsequent brief pressing increases the
target speed by 1 km/h or 1 mph.
• Button +RES is pressed and held. – The target speed
increases in increments of 5 km/h or 5 mph.
• Button ‑SET is pressed. – The cruise control function is acti-
vated and the current speed is maintained. Every subsequent
brief press reduces the target speed by 1 km/h or 1 mph.
• Button ‑SET is pressed and held. – The target speed
decreases in increments of 5 km/h or 5 mph.
Info
After activation of the cruise control function, the throttle
grip can be turned back to the basic position. The selected
speed will be maintained.
If no target speed has yet been saved, this can be saved
once using the +RES button.
If the cruise speed is exceeded for less than 30 seconds
by turning the throttle grip, the cruise control remains acti-
vated.
To switch off the cruise control system function press the cruise
control system button again.
In addition, the cruise control system function is deactivated when
one of the following events occurs:
– Operating the hand brake lever
– Operating the foot brake lever
– Operating the clutch lever
– Gear change without quickshifter+
– Turning the throttle grip beyond the basic position
– Control of the motorcycle traction control (MTC)
– Slip at the rear wheel or lifting front wheel
– A fault occurring, which impairs the cruise control system
function
– Exceeding the target speed for more than 30 seconds when
overtaking

KTM 1290 SUPER DUKE R 2021 Specifications

General

Displacement	1301 cc
Transmission	6-speed
Rear Suspension	WP APEX monoshock, fully adjustable
Seat Height	835 mm
Fuel Tank Capacity	16 liters
Dry Weight	189 kg
Bore x Stroke	108 mm x 71 mm
Compression Ratio	13.5:1
Fuel System	Electronic fuel injection
Lubrication	Forced oil lubrication with 3 oil pumps
Wheelbase	1482 mm
Traction Control	MTC (Motorcycle Traction Control), lean-angle sensitive
Engine Type	V-Twin, 4-stroke
Power	180 hp
Torque	140 Nm @ 8000 rpm
Frame	Chromium-Molybdenum steel frame, powder coated
Front Suspension	WP APEX 48
Front Brake	320 mm discs
Rear Brake	Brembo two-piston caliper, 240 mm disc
Clutch	PASC slipper clutch, hydraulically actuated
ABS	Bosch 9.1 MP (incl. Cornering ABS and Supermoto mode)