2. Remove the engine-side covers.
(1) Engine side cover
(2) Bolt
(A) LH
(1) Engine side cover
(2) Wing bolt
(A) RH
To attach the engine-side covers, follow the following
procedure:
1. Insert the bottom pin of each of the engine-side
covers.
2. Hook the engine-side covers on.
3. Tighten the bolts of the engine-side covers.
DAILY CHECK
For your own safety and maximum service life of the
machine, perform a thorough daily inspection before
operating the machine to start the engine.
WARNING
To avoid personal injury or death:
Take the following procedure before checking the
tractor:
1. Park the machine on firm and level ground.
2. Set the parking brake.
3. Lower the implement to the ground.
4. Release all residual pressure from the hydraulic
system.
5. Stop the engine and remove the key.
1. Walk around inspection
Before checking the tractor, inspect surroundings of it.
Look around and under the tractor for such items as
loose bolts, trash build-up, oil or coolant leaks, or
broken or worn parts.
2. Checking the fuel tank and
refueling
WARNING
To avoid personal injury or death:
• Never use fire.
• Do not smoke while refueling.
• Be sure to stop the engine and remove the
starter key before refueling.
• Be sure to close the fuel-tank cap after
refueling.
• Use properly grounded fueling systems. Make
sure that there is no static discharge.
To avoid allergic skin reaction:
• Wash hands immediately after contact with
diesel fuel.
IMPORTANT :
• Do not permit dirt or trash to get into the fuel
system.
• Be careful not to let the fuel tank become
empty, otherwise air will enter the fuel system,
necessitating bleeding before the next engine
start.
• Be careful not to spill during refueling. If a spill
should occur, wipe off the fuel at once, or it may
cause a fire.
• To prevent condensation (water) accumulation
in the fuel tank, fill the fuel tank before parking
overnight.
1. Turn the key switch to “ON” and check the amount
of fuel by fuel gauge.
DAILY CHECK PERIODIC SERVICE
To Next Page
General
