7. Install the radiator cap securely.
IMPORTANT :
• Securely tighten the radiator cap. If the
radiator cap is loose or improperly fitted,
water may leak out and the engine could
overheat.
8. Fill with coolant up to the “FULL” mark of recovery
tank.
Coolant capacity
Radiator
6.0 L
(6.3 U.S.qts.)
Recovery tank
0.6 L
(0.6 U.S.qts.)
(1) Drain plug
(1) Radiator cap
(2) Recovery tank
(A) Full
(B) Low
9. Start and operate the engine for a few minutes.
10. Stop the engine, remove the starter key, and let the
engine cool.
11. Check the coolant level of the recovery tank and
add coolant if necessary.
12. Properly dispose of the used coolant.
1.1 Antifreeze
WARNING
To avoid personal injury or death:
• When using the antifreeze, put on some
protection such as rubber gloves. Antifreeze
contains poison.
• If someone drank the antifreeze, seek
immediate medical help. Do not ask the person
to throw up unless told to throw up by a poison
control or a health care professional. Use
standard first aid and CPR for signs of shock or
cardiac arrest. Call your local poison-control
center or your local emergency number for
further assistance.
• When antifreeze comes in contact with the skin
or clothing, wash off antifreeze immediately.
• Do not mix different types of antifreeze. The
mixture can produce chemical reactions
causing harmful substances.
• Antifreeze is extremely flammable and
explosive under certain conditions. Keep fire
and children away from antifreeze.
• When draining the fluids from the engine, set a
container underneath the engine body.
• Do not pour waste onto the ground, down a
drain, or into any water source.
• Also, follow the relevant environmental
protection regulations when disposing of
antifreeze.
Always use a 50/50 mix of long-life coolant and clean,
soft water in Kubota engines.
Consult your local Kubota Dealer concerning coolant
for extreme conditions.
• Long-life coolant (LLC) comes in several types. Use
ethylene glycol (EG) type for this engine.
• Before employing LLC-mixed cooling water, fill the
radiator with fresh water and empty it again. Repeat
filling and emptying the radiator with fresh water 2
times or 3 times to clean up the inside.
• Mixing the LLC
Premix 50 % LLC with 50 % clean, soft water.
When mixing, stir LLC-mixed water up well, and
then fill into the radiator.
• The procedure for the mixing of water and
antifreeze differs according to the type of the
antifreeze and the ambient temperature. Refer to
SAE J1034 standard, more specifically also to SAE
J814c.
Vol (%)
Antifreeze
Freezing Point Boiling Point
*1
℃
(℉)
℃
(℉)
50
-37
(-34)
108
(226)
PERIODIC SERVICE SERVICE EVERY 2000 HOURS OR 2 YEARS
To Next Page
Loading...
Need help?
General
