Hitting the loader valve cover with the armrest may
causes damage to the loader valve cover.
(1) Loader valve cover
(2) Seat
(3) Armlest
(A) Up
(1) Loader valve cover
(2) Seat
(A) Forward
REMOVING THE TRACTOR
FROM STORAGE
1. Check the air pressure of the tires and inflate the
tires if they are low.
2. Jack the tractor up and remove the support blocks
from under the front and rear axles.
3. Before installing the battery, be sure that it is fully
charged.
4. Install the battery.
5. Check the tension of the fan belt.
6. Check the fluid levels and any attached
implements.
Check the following:
• Engine oil
• Transmission oil and hydraulic oil
• Engine coolant
• Implement if any fluid is used
7. Start the engine. Check all gauges.
8. If all gauges are functioning properly and reading
normal, follow the following procedure.
a. Move the tractor outside.
b. Once outside, park the tractor.
c. Let the engine idle for at least 5 minutes.
d. Shut off the engine.
9. Walk around tractor and perform a visual inspection
looking for evidence of oil or water leaks.
10. With the engine fully warmed up, release the
parking brake and test the brakes for proper
adjustment as you move forward.
Adjust the brakes if necessary.
STORAGE OF THE TRACTOR REMOVING THE TRACTOR FROM STORAGE
To Next Page
Loading...
Need help?
General
