3. Fill with the new engine oil from the oil inlet up to
the upper notch on the dipstick.
(See LUBRICANTS, FUEL, AND COOLANT on
page 96)
Engine oil capacity with engine oil filter
6.7 L
(7.1 U.S.qts.)
IMPORTANT :
• Use the following engine oil for the engine.
Engine oil DPF-compatible oil (CJ-4 or better quality)
(1) Oil inlet
(1) Dipstick (A) Range that engine oil level is
acceptable within
2. Replacing the engine oil filter
WARNING
To avoid personal injury or death:
• Be sure to stop the engine and remove the
starter key before changing the engine-oil filter
cartridge.
• Allow the engine to cool down sufficiently
because the engine oil can be hot and can burn.
IMPORTANT :
• To prevent serious damage to the engine, use
only a Kubota genuine filter.
1. Remove the engine-oil filter.
(1) Engine oil filter
2. Put a film of clean engine oil on the rubber seal of
the new engine-oil filter.
3. Tighten the engine-oil filter quickly until it contacts
the mounting surface.
4. Tighten the engine-oil filter by hand only an
additional 1/2 turn.
After replacing the engine-oil filter, the engine oil
normally decreases a little.
5. Make sure that the engine oil does not leak through
the seal and be sure to check the oil level on the
dipstick.
6. Then, fill the engine oil up to the prescribed level.
3. Changing the transmission fluid,
replacing the hydraulic oil filter, and
cleaning the magnetic filter
WARNING
To avoid personal injury or death:
• Be sure to stop the engine and remove the
starter key before changing the hydraulic oil-
filter cartridge.
• Allow the engine to cool down sufficiently
because the transmission oil can be hot and
can burn.
IMPORTANT :
• To prevent serious damage to the hydraulic
system, use only a Kubota genuine filter.
1. Remove the drain plugs at the bottom of the
transmission case and drain the transmission oil
completely into the oil pan.
SERVICE EVERY 400 HOURS PERIODIC SERVICE
To Next Page
Loading...
Need help?
General
