9. If the transmission oil level is low, add the
transmission oil to the prescribed level.
Transmission oil ca-
pacity
Manual transmission
28.5 L
(7.5 U.S.gals.)
HST
26.0 L
(6.9 U.S.gals.)
10. Make sure that the transmission fluid does not leak
past the seal on the hydraulic-oil filter.
IMPORTANT :
• Do not operate the tractor immediately after
changing the transmission fluid.
Operate the engine at medium speed for a few
minutes to prevent damage to the transmission.
4. Replacing the fuel filter
1. Remove the fuel filter.
(1) Fuel filter
2. Put a film of clean fuel on the rubber seal of the
new filter.
3. Tighten the fuel filter quickly until it contacts the
mounting surface.
4. Tighten the fuel filter by hand only an additional 1/2
turn.
5. Bleed the fuel system.
(See Bleeding the fuel system on page 127)
(1) Fuel shutoff-valve
(A) Close
(B) Open
5. Cleaning the water separator
This job should not be performed in the field, but in a
clean place.
1. Disconnect the connector of water sensor.
2. Close the fuel shutoff-valve.
3. Loosen the cup and remove it, then rinse the inside
with kerosene.
4. Remove the element and dip it in the kerosene to
rinse.
IMPORTANT :
• If a fuel element is broken, replace it with
new one.
5. After cleaning, reassemble the water separator,
keeping out dust and dirt.
6. Connect the connector of water sensor.
(1) Water sensor connector
(2) Fuel shutoff-valve
(3) Cup
(4) Element
(A) Close
SERVICE EVERY 400 HOURS PERIODIC SERVICE
To Next Page
Loading...
Need help?
General
