HYDRAULIC UNIT
IMPORTANT :
• Do not operate the hydraulic unit until the
engine is warmed up. If you operate the
hydraulic unit when the engine is still cold, the
hydraulic system may be damaged.
• If you hear noises when implement is lifting
after the hydraulic-control lever has been
activated, the hydraulic mechanism is not
adjusted properly. Unless corrected, the
hydraulic unit will be damaged. Contact your
Kubota Dealer for adjustment.
3-POINT HITCH CONTROL
SYSTEM
WARNING
To avoid personal injury or death:
• Before using the 3-point hitch controls, make
sure that no person or object is in the area of
the implement or 3-point hitch.
• Do not stand on or near the implement or
between implement and tractor when operating
the 3-point hitch controls.
1. Position control of 3-point hitch
mounted implement
Position control will control the working depth of 3-point
hitch mounted implements regardless of the amount of
pull required.
(1) Position control lever
(A) Float
(B) Down
(C) Up
2. Float control of 3-point hitch
mounted implement
Set the position-control lever in the “FLOAT” position to
move the lower links freely along with the ground
conditions.
(1) Position control lever (A) Float
(B) Down
(C) Up
3. 3-point hitch lowering speed
WARNING
To avoid personal injury or death:
• Fast lowering speed may cause damage or
injury. You should adjust the lowering speed of
3-point hitch-mounted implement to 2 or more
seconds.
You can control the lowering speed of the 3-point hitch
by adjusting the 3-point hitch lowering-speed-knob.
(1) 3-point hitch lowering speed
knob
(A) Fast
(B) Slow
(C) Lock
3-POINT HITCH CONTROL SYSTEM HYDRAULIC UNIT
To Next Page
Loading...
Need help?
General
