KYMCO Super 8 50 Service Manual

12. FRONT WHEEL/FRONT BRAKE/
FRONT SUSPENSION
12-12
Super 8 50
Place the brake master cylinder on the
handlebar and install the holder with “up”
mark facing up. Be sure to align the punch
mark with the holder joint.
First tighten the upper bolt and then tighten
the lower bolt.
Torque: 3.0～4.0kgf-m
Install the brake fluid pipe with the attaching
bolt and two sealing washers.
Install the handlebar covers. (

12-3)
Fill the brake reservoir with recommended
brake fluid to the upper limit and bleed air
according to the method stated in 12-10.
BRAKE CALIPER (FRONT)
Removal
Remove the brake caliper.
Place a clean container under the brake
caliper and disconnect the brake fluid pipe
from the caliper.
Do not spill brake fluid on any coated
surfaces.
＊
Punch Mark
Bolts
“Up” Mark
Bolt
Bleed Valve
Bleed Valve
Brake Caliper

KYMCO Super 8 50 Specifications

General

Displacement	49.5 cc
Fuel System	Carburetor
Ignition	CDI
Front Suspension	Telescopic Fork
Front Brake	Disc
Rear Brake	Drum
Front Tire	120/70-12
Rear Tire	130/70-12
Cooling System	Air
Transmission	CVT Automatic
Seat Height	780 mm
Wheelbase	1, 280 mm