KYMCO Super 8 50 Service Manual

5. FUEL INJECTION SYSTEM Super 8 50
5-6
How To Show Failure Code
 You can read the failure code by as
below :
 Turn switch on. The CELP will be
lighted for 2 seconds then off. The CELP
start to blink to show the failure codes
 (The number of blinks from 1 to 25).
 If vehicle got more than one failure code,
the CELP will be shown from lower
number failure code and then show the
other higher number one after four
seconds. All the failure codes would be
shown repeatedly.
How To Reset Failure Code
 After repairing the trouble, you should
clear the failure code or it will still exist
in the ECU memory. When you do a next
maintain, it will show again and you get
confuse.
 Turn switch on. The CELP will be
lighted for two seconds then off.
 The CELP begins to blink to show the
failure codes.
 The self-diagnosis memory data will be
erased when all the failure codes has
showed for four cycles.

KYMCO Super 8 50 Specifications

General

Displacement	49.5 cc
Fuel System	Carburetor
Ignition	CDI
Front Suspension	Telescopic Fork
Front Brake	Disc
Rear Brake	Drum
Front Tire	120/70-12
Rear Tire	130/70-12
Cooling System	Air
Transmission	CVT Automatic
Seat Height	780 mm
Wheelbase	1, 280 mm