Security
8-4 ADVANCED OPERATION GUIDE
Touch Panel Display after the Security Kit is Installed
Hard Disk Icon Display
In Security Mode,
the Security Kit has
been properly
installed and is
running. The hard
disk icon appears on
the lower right side
of the touch panel in
Security Mode.
NOTE: If the hard disk icon does not appear on the normal screen, it is
possible that the Security Mode is not ON. Call service.
The hard disk icon display changes as follows during overwriting
The table below shows the icons displayed and their descriptions.
CAUTION: Do not turn the main power switch off during overwriting (while
is displayed). It may crash the hard disk.
NOTE: If you turn the machine off at the main power switch during
overwriting or erasing, unerased data will be left on the hard disk. Turn the
machine back on at the main power switch. Overwriting or erasing
automatically resumes. If you accidentally turn the main power switch off
during overwriting or initialization, the hard disk icon might not switch to
the second icon shown above. This would be caused by a possible crash
or failed overwriting of the data to be overwritten. This will not affect
subsequent overwriting processes. However, system initialization is
recommended so as to return to normal stable operations. (Initialization
should be performed by the administrator following the steps in System
Initialization on page 8-8.)
Status 10/10/2007 10:10
Original
Zoom
Paper
100%
---
:
:
:
---
Image
Quality
Ready to copy.
Set Original.
Copies
Copy Image
Org./Paper /
Finishing
Quick Setup Layout/Edit Advanced
Setup
1
Normal 0 Letter
Zoom Density Paper
Selection
1-sided
>>1-sided
Text+Photo Collate
Duplex Original
Image
Collate/
Offset
Auto
Plain
Preview
Icon displayed Description
There is unwanted data on the hard
disk.
Overwriting the unwanted data
The unwanted data is overwritten.
To Next Page
Loading...
Need help?
General
