Copying Functions
ADVANCED OPERATION GUIDE 1-55
1
Repeat Copy
Enable additional copies in the desired quantity as necessary after a copy
job is completed. For confidential documents, you can set up a pass code
for the use of Repeat Copy. In such a case, the correct pass code must be
entered when using Repeat Copy or copies will not be delivered.
IMPORTANT: A Repeat Copy job is cleared when the main power switch
is turned off.
Repeat Copy is not available when the machine is equipped with the
optional Security Kit.
Repeat Copy cannot be used when the maximum number of Repeat Copy
jobs to retain in the document box is set to zero (refer to Maximum Number
of Repeat Copy Jobs Retained on page 1-56).
You can select Repeat Copy as default setting. Refer to Repeat
Copying on page 6-35.
Giving a file name to a copy job will facilitate identification of the data when
copying (refer to File Name on page 1-53).
Selecting Repeat Copy
Use the procedure below to select repeat copying.
1
Press the Copy key.
2
Press [Advanced Setup] and then [Repeat Copy].
3
Press [On].
To register a
password, press [#
Keys] and enter a 4-
digit password.
IMPORTANT: If you forget the pass code, Repeat Copy will be
unavailable. Make a note of the pass code beforehand if necessary.
4
Press [OK].
Status 10/10/2007 10:10
Ready to copy.
Copies
Cancel OK
Repeat Copy
Press [OK] to display
Add Shortcut
Off
On
Password(4 digits)
# Keys
1
the image.
To Next Page
Loading...
Need help?
General
