Step 1. Disable the HTTP port (80) and use HTTPS (443) instead.
The setting is available in the following ways:
▪
section).
▪ section).
Step 2. Set the password and enable the authentication.
The setting is available in the following ways:
▪ Network section)
▪ Setting Password for Authentication and the
Enabling Authentication sections).
▪ Setting a Password for Authentication and the
Enabling Authentication sections).
Step 3. Disable 6107 port, use Lightware REST API HTTPS (443 port) or WSS for LW3 protocol to control the device.
ATTENTION!
be controlled only with protocol commands.
The setting is available in the following ways:
▪
section).
▪ section).
Step 4. Disable the remaining unsecured Serial over IP ports (8001 and 8002).
The setting is available in the following ways:
▪
section).
▪ section).
with
(6107) ports.
open. This feature allows real-time communication such as controlling the device with LW3 protocol commands.
To Next Page
Loading...
Need help?
General
