Embedded Audio Input
Audio port properties window of HDMI input
Available settings
Port name
The name of a port can be changed by typing the new name and clicking on the Set button. The following
dot (.). Max length: 63 characters.
Lock #lock #unlock
The port can be locked to the currently connected output ports by adding a tick. If the port is locked, the
crosspoint state of this port cannot be changed.
Mute #mute #unmute
is transmitted from the input port.
Autoselect
Autoselect feature makes the switching of an input to an output without human intervention possible. The
crosspoint state changes based on the active input signals.
The following operation policies can be set:#autoselect # videoautoselect
Disable autoselect: crosspoint state change happens manually.
First detect: selected input port is kept connected to the output as long as it has an active signal.
Last detect mode: it is always the last attached input that is selected to be transmitted.
Individual input settings: it is always the highest priority active input that is selected to be transmitted (1- highest
priority, 100- lowest priority).
Pay attention to the following settings for the proper operation of the Autoselect function:
–
– Be sure that all inputs are enabled with the green tick on the right side;
– Always click on the Apply autoselect settings button after the changes to launch the new settings.
See more details about the feature in the The Autoselect Feature section.
Autoselect settings in HDMI output panel
To Next Page
Loading...
Need help?
General
