Mindray BeneHeart D2 User Manual

Defibrillator/Monitor Operator’s Manual 22 - 1
22 Battery
22.1 Battery Introduction
The equipment is designed to operate on battery power when external power supply is not available. The
battery is charged whenever the equipment is connected to AC mains or the DC power supply through an
external DC/AC adapter, regardless of whether or not the equipment is currently turned on. In case of power
failure, the equipment will automatically run power from internal batteries. So we recommend you always install
a fully charged battery in the equipment.
The equipment is configured with one smart lithium ion battery which is free of maintenance.
On-screen battery symbols indicate the current battery charge status:
■ ≤100%, but >80% of capacity
■ ≤80%, but >60% of capacity
■ ≤60%, but >40% of capacity
■ ≤40%, but >20% of capacity
■ ≤ 20% of capacity
■ Low battery and charging is required immediately
■ Battery is not installed
You can also check the battery’s charge status by pressing the fuel gauge button on the battery to illuminate the
battery gauge. The fuel gauge consisting of 5 LEDs, each LED represents a charge of approximately 20% of
capacity.
22.2 Battery Safety Information
WARNING
• The batteries should be charged in this equipment or in a device approved by the equipment
manufacturer.
• Keep the batteries out of children’s reach.
• Use only specified batteries.
NOTE
• Always connect the equipment to AC mains whenever it is possible.
• Always install a fully charged battery in the equipment.
• After long term use, the power capacity indicated by the battery symbol may be different from the
actual capacity. Always observe the alarm information displayed on the screen.
• Remove the battery before transporting the equipment or if the equipment will not be used for a
long time.

Mindray BeneHeart D2 Specifications

General

Brand	Mindray
Model	BeneHeart D2
Category	Medical Equipment
Language	English