8 - 4 Defibrillator/Monitor Operator’s Manual
â—† Select [Refresh] if there is power failure or CPR is interrupted within five minutes, and then select the
desired CPR event.
• A CPR event is automatically saved in the equipment when the interruption time exceeds five
minutes.
• You should select [Refresh] to save a CPR event before disconnecting the CPR sensor from the
equipment.
8.2.5 Uploading CPR Data
If you use the CPR sensor independently, you can connect it to the equipment, and upload the latest one-hour
data to the equipment. You can also review CPR events uploaded from the CPR sensor on the equipment.
For details about CPR event review, refer to 8.2.4Reviewing CPR Events.
To Next Page
Loading...
Need help?
General
