Mindray BeneHeart D2 User Manual

2 - 2 Defibrillator/Monitor Operator’s Manual
2.2.1 AED
The AED mode is to be used only on cardio arrest patients. The patients must be:
■ Unresponsive
■ Not breathing or not breathing normally
2.2.2 Manual Defibrillation
Asynchronous defibrillation is the initial treatment for ventricular fibrillation and ventricular tachycardia in patients
that are pulseless and unresponsive. Synchronized cardioversion is intended for termination of atrial fibrillation.
2.2.3 Noninvasive Pacing
Noninvasive pacing therapy is intended for patients with symptomatic bradycardia. It can also be helpful in
patients with asystole, if performed early.
2.2.4 ECG
The ECG monitoring function is used to monitor and/or record the patient’s ECG waveform and heart rate.
2.2.5 Resp
The respiration monitoring function is used to continuously monitor the patient’s respiration rate and
respiration waveform.
2.2.6 PR
The PR function is intended to measure patient’s arterial pulsation in arterial blood.
2.2.7 SpO
2
The SpO
2
function is intended to measure patient’s oxygen saturation in arterial blood.
2.2.8 NIBP
The NIBP function is intended for non-invasive measurement of a patient’s arterial blood pressure.
2.2.9 CO
2
The CO
2
function is intended for monitoring a patient’s exhaled carbon dioxide and to provide a respiration rate.
2.2.10 CPR Feedback
The CPR sensor can be connected to the equipment to provide real-time CPR feedback, including the chest
compression depth, rate and interruption time.

Mindray BeneHeart D2 Specifications

General

Brand	Mindray
Model	BeneHeart D2
Category	Medical Equipment
Language	English