Defibrillator/Monitor Operator’s Manual 1 - 3
devices are a possible source of interference as they may emit higher levels of electromagnetic
radiation.
• Before connecting the equipment to the power line, check that the voltage and frequency ratings of
the power line are the same as those indicated on the equipment’s label or in this manual.
• Do not loop the patient cabling into a tight coil or wrap around the device, as this can damage the
patient cabling.
• Always install or carry the equipment properly to avoid damage caused by drop, impact, strong
vibration or other mechanical force.
• Dry the equipment immediately in case of rain.
• Never charge and deliver shock frequently in non-clinical situations. Otherwise equipment damage
could occur.
1.1.4 Notes
• Put the equipment in a location where you can easily view and operate the equipment.
• The equipment uses a mains plug as isolation means to the mains power supply. Do not locate the
equipment in a place difficult to operate the mains plug.
• During normal use, the operator shall stand in front of the equipment.
• Keep this manual in the vicinity of the equipment so that it can be obtained conveniently when
needed.
• If the equipment operates on a DC power supply, a DC/AC adapter we supply should be used.
• This manual describes all features and options. Your equipment may not have all of them.
1.2 Equipment Symbols
Symbol Description Symbol Description
Refer to instruction manual/booklet General warning sign
Dangerous voltage Shock button
Manufacturer Date of manufacture
Battery indicator Alternating current
Equipotentiality Computer network
DEFIBRILLATION-PROOF TYPE CF APPLIED
PAR T
DEFIBRILLATION-PROOF TYPE BF APPLIED
PAR T
Protected against solid foreign objects of
1,0 mm Ø and greater
Protection against vertically falling water
drops
Protected against solid foreign objects of
1,0 mm Ø and greater
Protected against splashing water
To Next Page
Loading...
Need help?
General
