Anesthesia Gas Monitoring
18-9
îš„ FiAA ALM LO
Set the lower limit of FiAA which triggers the alarm
îš„ APNEA ALM
Used to set up the apnea alarm time.
Options: 20s, 25s, 30s, 35s and 40s.
NOTE
z Never turn off APNEA alarm.
Adjust Wave Amplitude Menu
Select ADJUST WAVE AMP>> in AG SETUP menu. The following menu appears.
Figure 18-7
ADJUST WAVE AMP menu
In the ADJUST WAVE AMP menu, you can set the following items.
îš„ CO2 WAVE
AMP
Used to adjust the display amplitude of CO
2
waveform.
Options: 1, 2, 3, 4, and 5.
îš„ N2O WAVE
AMP
Used to adjust the display amplitude of N
2
O waveform.
Options: 1, 2, 3, 4, and 5.
îš„ O2 WAVE AMP
Used to adjust the display amplitude of O
2
waveform.
Options: 1, 2, 3, 4, and 5.
îš„ AA WAVE AMP
Used to adjust the display amplitude of AA waveform.
Options: 1, 2, 3, 4, and 5.
Where, 1 indicates the minimum amplitude, and 5 indicates the maximum.
Default Menu
Select DEFAULT >> in AG SETUP menu. The AG DEFAULT CONFIG menu
appears. In this menu, you can select FACTORY DEFAULT CONFIG or USER
DEFAULT CONFIG. After selecting that, the system will prompt to confirm the
selection.
To Next Page
Loading...
Need help?
General
