40
Chapter 3 Installation and Connection
VIDEO SYSTEM OTV-SI
3.7 Connection to a wall mains outlet
Only connect this instrument to a wall mains outlet. Failure to
do so may cause an electric shock or fire.
• Secure the power cord so that it will not be accidentally
disconnected during the procedure. The endoscopic image
will disappear if the power cord is disconnected during use.
• Do not allow the power cord to become wet. A wet power
cord may cause an electric shock.
• Make sure that the wall mains outlet and isolation
transformer have adequate electrical capacities. Otherwise,
fire or power fluctuations can occur.
• Do not bend, pull, twist or squeeze the power cord. an
electric shock, equipment damage or fire can result.
• When using non-medical ancillary electrical equipment,
always connect the equipment to a wall mains outlet via an
isolation transformer. Otherwise, an electric shock or fire can
result.
• Never use a 3-pin converter plug to connect to a 2-pin wall
mains outlet, as this will prevent proper grounding and could
cause an electric shock.
• Never use a table tap. Always connect the power cord
directly to a wall mains outlet. Connecting to a table tap can
result in fire.
To Next Page
Loading...
