Olympus OTV-SI - 5.8 Patient data entry;deletion

Chapter 5 Operation
93
VIDEO SYSTEM OTV-SI
 Using the keyboard
Press the “F6” key on keyboard. Each time this key is pressed, the image
enhancement level is changed.
• When the menu is not displayed, pressing the remote control
switch that is set to “ENH.[ ]” or the “F6” key on the keyboard
displays the following words at the bottom left of the video
monitor screen.
• The figure inside the brackets is variable depending on the
image enhancement level.
• When the image enhancement is set to “3 (HIGH)”, noise in
the images may increase.
• The set image enhancement level is retained when the video
system is turned OFF and turned ON again.
• When using fiberscopes, it is recommended to set the
ENHANCE function to “0 (OFF)” to reduce moire patterns.
5.8 Patient data entry/deletion
Patient data can be entered or deleted using the keyboard (optional).
Patient data entry
1.
If the video monitor does not display the menu, press the remote control
switch for execution or for selection, the “F1”, “Enter”, “  ”, “  ”,“” or “”
key on the keyboard to display the menu.
2. Press the remote control switch for selection, the “” or “” key on the
keyboard and select “NEXT” (see Figure 5.6 on page 57).
ENHANCE[ 2]
VISY218