8.60
Steering and Suspensions
RMK 144/Switchback Assault
Pivots/Rear Idler
Assembly Notes
• Never re-use lock nuts. Always replace with new parts.
• All pivots must rotate freely after tightening fasteners.
• Install rear idler adjust spacers with flat side facing adjuster screw.
A: 35 ft-lbs (47.4 Nm)
B: 35 ft-lbs (47.4 Nm) Apply Loctite® 262™
Some rail shaft fasteners are pre-coated with locking
agent. Never re-use these fasteners once removed.
Always use new pre-coated fasteners.
INNER SHAFT
SPACER
SHAFT
REAR IDLER WHEEL
A
A
A
B
A
A
A
A
INNER SHAFT
INNER SHAFT
REAR PIVOT
REAR TRACK SHOCK PIVOT
INNER SHAFT
WASHERS
SPACERS
SPACER
WASHER
B
STANDARD FASTENERS
RMK REAR IDLERS
A
A
To Next Page
Loading...
Need help?
General
