2.22
Maintenance
16. On 2013 models, install the supply hose connector
onto the fuel pump flange fitting. Once seated, push
lock in to secure the connector. Verify an audible
“click” is heard when the lock tabs snap into place. Pull
up firmly on the connector to verify it is secured to the
fuel pump flange fitting.
17. Inspect the hoses making sure none are worn or
d
amaged.
18. Reinstall the clutch cover. Torque cover nuts to
spec
ification.
19. Reconnect the ECU wiring harness connectors.
20. Install the ECU bracket onto the oil tank
. Reinstall the
oil tank. Torque mount screw to specification.
21. Reinstall the drive belt. Replace the hood and door
p
anels.
Fuel Hose Inspection
Inspect all fuel hoses as part of periodic maintenance.
Replace any fuel hose if the inner rubber core show signs
of wear.
Fuel Tank Vent System
All models feature a fuel tank vent / vacuum check valve
system.
The rollover check valve prevents fuel from escaping the
t
ank in the event of a vehicle rollover.
The rollover check valve is not serviceable. When
inspecting
the system, verify the hose is not kinked.
PUSH LOCK IN TO SECURE CONNECTOR
INNER RUBBER HOSE WORN = REPLACE FUEL HOSE
To Next Page
Loading...
Need help?
General
