10.18
Battery and Electrical Systems
5. After pressing MODE to accept the last digit, view the
display screen. SECURE ON displays if the system
locks. Engine RPM speed is now limited and the
snowmobile cannot be driven.
NOTE: When the engine is running and security is
locked, the display
will alternate between SECURE ON
and ENTER CODE.
6. If an incorrect code is entered, BAD CODE will be
dis
played. Wait until the display returns to the ENTER
CODE screen and then re-enter the correct pass
code.
Security System: Unlocking
NOTE: Use the MODE button on the cluster when
performing procedure on models featuring the
analog/digital instrument cluster.
1. When the engine is running and security is locked, the
display will
alternate between SECURE ON and
ENTER CODE.
NOTE: When the system is locked and the engine
temp
erature is above 120°F (49°C), the correct pass
code must be entered within 60 seconds or the engine
will shut down.
• SEL
= Advances up 1 digit (0 to 9 to 0)
• MODE = Enter and move 1 digit to right
2. When ENTER CODE displays, press and release
SEL
to advance the digit. When the first digit of your
security code is displayed, press and release MODE
to accept the digit and move to the next digit.
3. Continue to use MODE and SEL to select and accept
th
e remaining two digits of the code.
4. After pressing MODE to accept the last digit, view the
display s
creen. SECURE OFF displays if the system
unlocks.
5. If an incorrect code is entered, BAD
CODE will be
displayed. Wait until the display returns to the ENTER
CODE screen and then re-enter the correct pass
code.
To Next Page
Loading...
Need help?
General
