4
4.11
9924864 - 2012-2014 SPORTSMAN 800 / 6X6
© Copyright 2013 Polaris Sales Inc.
Initial Priming / Starting Procedure
NOTE: The Injection system must be purged of all
air prior to the initial start up, and/or any time the
system has been disassembled.
If the EFI system is completely empty of fuel or has been
disassembled and repaired:
1. Cycle the key switch from “OFF” to “ON” 6 times,
waiting for approximately 3 seconds at each “ON”
cycle to allow the fuel pump to cycle and shut down.
2. Once step 1 is completed, turn the key switch to
“START” until the engine starts or 5 seconds has
passed.
3. If the engine failed to start, repeat step 1 for 2 more
cycles and attempt to start the engine.
If the engine fails to start, a problem may still exist,
and should be diagnosed.
IMPORTANT: Accurate testing of EFI
components is recommended utilizing the
Polaris Diagnostic Software (dealer only).
FUEL SYSTEM - GENERAL
To Next Page
Loading...
Need help?
General
