Making Printer Settings Using the Control Panel
58
5
Host Interface Menu
You can set configurations about network connections and communication. The
changed configuration holds even if the printer is turned off.
Changing the Host Interface Menu
Use the following procedure to change the settings for Network Setup.
A Press the {Menu} key.
The menu screen appears.
B Press {U} or {T} to display [Host Interface], and then press the {#Enter} key.
C Press {U} or {T} to display [Network Setup], and then press the {#Enter} key.
D Press {U} or {T} to display [DHCP], and then press the {#Enter} key.
E Press {U} or {T} to display [On] or [Off] according to the network environ-
ment, and then press the {#Enter} key.
If you select [On], proceed to step
I
.
F Press {U} or {T} to display [IP Address], and then press the {#Enter} key.
G Specify the printer’s IP address using {U} or {T} keys, and then press the
{#Enter} key.
• To go to the next field, press the {#Enter} key.
• To go back to the previous field, press the {Escape} key.
H Set the subnet mask and gateway address.
Set values for each setting following the same procedure as for the IP address.
I Press the {Menu} key to return to the initial screen.
ASI066S
To Next Page
Loading...
Need help?
General