91
8. Special Operations under
Windows
Printing Files Directly from Windows
You can print files directly using Windows commands; "lpr" or "ftp".
Setup
Use the following procedure to make network environment settings.
A Enable TCP/IP using the control panel, and then set up the printer’s net-
work environment about TCP/IP including IP addresses.
TCP/IP of the printer is set as default.
B Install a TCP/IP in Windows to set up the network environment.
Consult the network administrator for the local setting information.
C To print, install “Printing service for UNIX” as the network application.
Reference
For details about setting up IPv4 address, see Hardware Guide.
For details about setting the IPv4 address of the printer using DHCP, see
p.116 “Using DHCP”.
This completes the setup for specifying a printer using an IPv4 address
when printing. When using a host name to specify a printer, proceed to
p.92 “Using a Host Name Instead of an IPv4 Address” and continue the
setup.
To Next Page
Loading...
Need help?
General