Configuration
34
4
D Press the {T} or {U} key to display [Frame Type (NW)], and then press the
{#Enter} key.
E Press the {T} or {U} key to select the frame type, and then press the {#Enter}
key.
F Press the {Menu} key.
The initial screen appears.
G Print a configuration page to confirm the settings made.
Reference
For details about printing the configuration page using control panel, see
p.16 “Test Printing”.
Setting the Ethernet Speed
You can set the speed that the printer will use for Ethernet communication. For
normal usage, the default setting [Auto Select] is suitable and does not need to be
changed. This setting allows two connected interfaces to automatically deter-
mine the optimum speed that they will communicate at.
Important
❒ Connection cannot be established if the selected Ethernet speed does not
match your network's transmission speed.
❒ The use of this feature is recommended. To use it, select [Auto Select].
Network Setup:
Frame Type (NW)
Router/HUB Printer
[10Mbps Half D.][10Mbps Full D.][100Mbps Half D.][100Mbps Full D.][Auto Select]
10Mbps Half
Duplex
———
10Mbps Full
Duplex
————
100Mbps Half
Duplex
—— —
100Mbps Full
Duplex
——— —
auto-negotia-
tion (auto se-
lection)
——
To Next Page
Loading...
Need help?
General