Ethernet Configuration
29
4
G Press the {T} or {U} key to display [DHCP], and then press the {#Enter} key.
H Press the {T} or {U} key to select [Off], and then press the {#Enter} key.
The address detected by the printer will appear.
I To specify the IP Address. Press the {T} or {U} key to display [IP Address],
and then press the {#Enter} key.
J Press the {T} or {U} key to enter the address.
Press the {T} or {U} key to enter the left most entry field of the address.
• To go to the next field, press the {#Enter} key.
• To go back to the previous field, press the {Escape} key.
K After setting values for all fields, press the {#Enter} key.
The [IP Address] menu appears.
L Set the subnet mask and gateway address. Press the {T} or {U} key to select
[Subnet Mask] or [Gateway Address], and then press the {#Enter} key.
Set values for each setting following the same procedure as for the IP address.
M After completing the settings, return to the initial screen by pressing the
{Menu} key.
Network Setup:
DHCP
DHCP:
Off
Network Setup:
IP Address
To Next Page
Loading...
Need help?
General