10
2. Troubleshooting Service Call Problems (SC
Codes)
2.1 What Are SC Codes?
If an error occurs during operation, the machine displays an SC code ("SCnnn",
where "nnn" is a three-digit number). The machine stops and cannot be used when
an SC code is displayed.
If an SC code appears:
1. Write down the SC number.
2. Turn off the main power switch.
Note: The main power switch is in the upper left corner behind the front left
cover.
3. Wait a few moments, then turn the machine on again.
In most cases, cycling the machine off and on will restore it to full operation.
4. If the SC code reappears, check it against the table (see, 2.2 SC Code List).
Check for the SC code in the following table (see 2.2 SC Code List). If the SC
code is listed in the table, carry out the recommended procedure.
-OR-
If the SC CODE is not listed in the following table (see 2.2 SC Code List),
contact your service representative.
To Next Page
Loading...
Need help?
General
