124
5.1.3 Trailing edge of stapled sheets close to the paper exit
Cause:
If the stapled sheets are curled strongly or become limp after delivery, the trailing
edge of the sheets may be too close to the paper exit when the paper is stacked.
If this happens, stapled sheets, when delivered, may push the previously delivered
sheet, resulting in paper bending or misfeeding.
This is likely to occur if:
• There is a tight curl on a delivered set of stapled sheets.
• Limp paper such as thin or recycled paper is used.
Output tray
Paper exit
Paper feed direction
Trailing edge
too near exit
CEZ593
Solution:
1.
Attach the Z-fold support tray.
2.
Print the image. Is the problem resolved?
Yes
Finished!
No
Go to the next step.
To follow the steps below, attach the decurler unit.
3.
In the [Adjustment Settings for Skilled Operators] menu, set [0116: Adjust
Paper Curl] to "Adjust Curl".
Select "Strong" or "Weak" to control the level of decurling as required.
4.
Print the image. Is the problem resolved?
Yes
Finished!
No
Contact your service representative.
Note:
• For details about attaching the Z-fold support tray, see "When Z-folded Paper Is
Not Properly Aligned" in the Troubleshooting supplied with the machine.
• If the Z-fold support tray is attached, the trailing edge of the ejected sheets will
not be too close to the paper exit, so no problem will occur. However, the stapled
sheets may not be stacked properly.
To Next Page
Loading...
Need help?
General
