136
5.2.5 Z-Folding is Not Performed Properly
Cause:
If a sheet is curled and its edge touches the guide board, proper folding may not be
possible.
Paper feed direction
Upward curl (radius 4 cm [1.6 in.] or less)
at leading edge of delivered paper.
CEZ572
Solution:
1.
Load the paper the other way up.
2.
Print the image. Is the problem resolved?
Yes
Finished!
No
Move to the next step.
To follow the steps below, attach the decurler unit.
3.
In the [Adjustment Settings for Skilled Operators] menu, set [0116: Adjust
Paper Curl] to [Adjust Curl: Weak].
4.
Print the image. Is the problem resolved?
Yes
Finished!
No
Contact your service representative.
Note:
• This folding error will not occur if uncurled paper is used or sheets that curl
downward.
To Next Page
Loading...
Need help?
General
