64
3.4.14 Dropouts (Character Voids)
Dropouts (character voids) occur when characters or lines are printed in black-and-
white mode.
CNT003
Note:
• To adjust the following settings, pre-register the type of paper in use as a custom
paper. For details about registering custom papers, see "Registering a Custom
Paper", Paper Settings Reference.
• Dropouts (character voids) do not occur on the first sheet.
• Decreasing the process speed may produce either or both of the following side
effects:
• Reduction in yields
• Occurrence of fusing blisters
Solution:
Carry out either of the following procedures:
Procedure 1: Changing the process speed
1.
In [Advanced Settings] for the custom paper in use, select [19: Process
Speed Setting].
2.
Decrease the value by one level.
If the present value is [High], select [Middle]. If it is [Middle], select [Low].
3.
Print the image. Is the problem resolved?
Yes
Finished!
No
Contact your service representative.
To Next Page
Loading...
Need help?
General
