81
The skew detection level is too high.
The skew detection level may be too high.
Decrease the skew detection level.
1.
In the [Adjustment Settings for Skilled Operators] menu, increase the value
in [0109: Skew Detection Level].
Increase the value to reduce the detection level.
If the problem persists even though the setting has reached its maximum
value, contact your service representative.
2.
Set [0108: Skew Detection] to [Off].
Note:
• If the skew detection level is reduced or the skew detection function is disabled,
no misfeed report will be displayed. However, this may result in paper skew
feeding. If you do not want this result, contact your service representative.
• If the machine wrongly detects skew, see p.85 "Wrong Detection of Skew".
4.2.5 If (J098) Appears
Cause:
Sheets cannot be positioned properly by image position adjustment.
Solution:
Depending on the cause of the problem, do one of the following:
The side fences in the paper trays are not positioned correctly.
Adjust the side fences to match the paper width.
When you close the paper tray, the side fences may become misaligned due to
the weight of the paper. To prevent this, close the paper tray slowly.
For details about loading paper, see "Loading Paper", About This Machine.
The paper size/orientation/type is not specified correctly.
In tray paper settings, specify the size, orientation, and type of the paper in use.
For details about tray paper settings, see "Changing Tray Paper Settings",
Paper Settings Reference.
To Next Page
Loading...
Need help?
General
