120
5. Post-Processing Option Troubleshooting
5.1 Finisher SR5030/Booklet Finisher SR5040
5.1.1 Delivered Sheets Are Not Stacked Properly
Solution:
Depending on the cause of the problem, do one of the following:
Coated paper is being used.
If coated paper is being used, attach the auxiliary tray for thin coated paper.
For details about attaching the auxiliary tray for thin coated paper, see "When
Coated Paper Is Not Properly Aligned" in the Troubleshooting supplied with the
machine.
There is airflow in the room.
Minimize the airflow. For instance, turn the air conditioner off.
Printed sheets are curled.
<If the decurler unit is attached>
1.
In the [Adjustment Settings for Skilled Operators] menu, adjust the degree
of decurling in [0116: Adjust Paper Curl].
To correct curls facing up, specify "Adjust Curl".
To correct curls facing down, specify "Adjust Curl".
Select "Strong" or "Weak" depending on the degree of decurling required.
<If the decurler unit is not attached>
1.
Load the sheets the other way up.
There are too many stacked sheets.
Reduce the number of the stacked sheets. To do this, suspend printing and
remove the stacked sheets, and then resume printing.
For details about suspending a print job, see "Pausing Print When Using
Finisher SR5030 or Booklet Finisher SR5040" in the Troubleshooting supplied
with the machine.
To Next Page
Loading...
Need help?
General
