126
5.2 Multi-Folding Unit
5.2.1 Inaccurate Folding (Folding Deviation)
Cause:
Depending on paper hardness, inaccurate folds may result. This is referred to as
folding deviation.
Solution:
Change the folding position by adjusting the position of the paper edge stopper for
folding.
• For multi-sheet folding, change the folding position using the following settings:
0601: Half Fold Position (Multi-sheet Fold)
0602: Letter Fold-out Position 1 (Multi-sheet Fold)
0603: Letter Fold-out Position 2 (Multi-sheet Fold)
0604: Letter Fold-in Position 1 (Multi-sheet Fold)
0605: Letter Fold-in Position 2 (Multi-sheet Fold)
• For single-sheet folding, change the folding position using the following settings:
54: Adjust Z-fold Position 1
55: Adjust Z-fold Position 2
56: Half Fold Position: Single-sheet Fold
57: Letter Fold-out Posn 1: Single-sheet Fld
58: Letter Fold-out Posn 2: Single-sheet Fld
59: Letter Fold-in Position 1: Single-sheet Fold
60: Letter Fold-in Position 2: Single-sheet Fold
61: Double Parallel Fold Position 1
62: Double Parallel Fold Position 2
63: Adjust Gate Fold Position 1
64: Adjust Gate Fold Position 2
65: Adjust Gate Fold Position 3
Note:
• For details about specifying settings in the [Adjustment Settings for Skilled
Operators] menu, see the Adjustment Item Menu Guide.
To Next Page
Loading...
Need help?
General
