101
4.8.8 Paper Edges Are Soiled (3)
120 mm
(4.8 in.)
40 mm
(1.6 in.)
CNT014
Cause:
The paper feed speed of the decurler unit is too high.
Note:
• To adjust the following settings, pre-register the type of paper in use as a custom
paper. For details about registering custom papers, see "Registering a Custom
Paper", Paper Settings Reference.
• Decreasing the paper feed speed of the decurler unit may result in creases,
scratches, or paper jams if thin paper is used.
Solution:
You can lessen the problem by decreasing the paper feed speed of the decurler
unit.
1.
In the [Adjustment Settings for Skilled Operators] menu, check the present
degree of decurling (Off, Weak, or Strong) in [0116: Adjust Paper Curl].
2.
In [Advanced Settings] for the custom paper in use, adjust the paper feed
speed of the decurler unit.
• If the degree of decurling is set to "Off", reduce the value in [51: Decurler
Feed Speed Adj: Curl Adj Off] by 0.5%.
• If the degree of decurling is set to "Weak", reduce the value in [52: Decurler
Feed Speed Adj: Curl Adj Weak] by 0.5%.
• If the degree of decurling is set to "Strong", reduce the value in [53:
Decurler Feed Speed Adj: Curl Adj Strg] by 0.5%.
3.
Print the image. Is the problem resolved?
Yes
Finished!
No
Keep decreasing the value by 0.5% until the problem is resolved.
If the problem persists even though the setting has reached its
minimum value, contact your service representative.
To Next Page
Loading...
Need help?
General
