Ricoh D074 Series Troubleshooting

51
3.4.5 Uneven Density within 90 mm (3.5 in.) of the Trailing Edge
Printing in the area extending approximately 90 mm (3.5 inches) from the trailing
edge is fainter or denser when the temperature or humidity is low.
90 mm
(3.5 in.)
90 mm
(3.5 in.)
CEZ564
Note:
• To adjust the following settings, pre-register the type of paper in use as a custom
paper. For details about registering custom papers, see "Registering a Custom
Paper", Paper Settings Reference.
Solution:
The solution depends on whether the area within 90 mm (3.5 inches) of the trailing
edge is denser or fainter.
<If the area within 90 mm (3.5 inches) of the trailing edge is fainter>
1.
In [Advanced Settings] for the custom paper in use, select [20: Transfer
Timing Roller Feed Speed Adj].
2.
Check the present value. Is it higher than +0.5%?
Yes
Contact your service representative.
No
Increase the value by 0.1 percentage point.
3.
Print the image. Is the problem resolved?
Yes
Finished!
No
Repeat Steps 1 to 3. If the problem persists even if you increase the
value to +0.5%, contact your service representative.

Ricoh D074 Series Specifications

General

Brand	Ricoh
Model	D074 Series
Category	Printer
Language	English