125
5.1.4 Sheets cannot be stapled properly
Cause:
When the sheets are fed to the staple unit inside the finisher, they may be overlaid,
resulting in a misalignment of 5 mm (0.2 inches) relative to each other after stapling.
When coated or other paper producing higher paper-to-paper friction is used, the
paper edges are not aligned properly, resulting in misaligned stapling.
This is likely to occur if:
• Coated or other paper producing higher paper-to-paper friction is used.
• Thin or other limp paper is used.
Solution:
Reduce the number of sheets to be stapled.
1.
In the [Adjustment Settings for Skilled Operators] menu, select [0416:
Number of Sheet Align for Stapling], and reduce the number of sheets to be
stapled.
2.
Print the image. Is the problem resolved?
Yes
Finished!
No
If the problem persists even though the setting has reached its
minimum value, contact your service representative.
Note:
• If the number of sheets to be stapled is reduced, paper alignment will take longer,
compromising the machine's throughput.
To Next Page
Loading...
Need help?
General
