146
6.2 Improving Throughput When Printing on Paper with
a Thickness Equivalent to Paper Weight 6 or 7
When printing on paper with a thickness equivalent to Paper Weight 6 or 7, the
machine's copy/print speed must be reduced to 70% of full speed (for A4 paper) so
that the degree of toner fixation can be enhanced.
However, depending on the type of paper in use and printed image, you can have
the machine print at full copy/print speed.
The following are requirements for improving throughput when using paper with a
thickness equivalent to Paper Weight 6 or 7:
• Uncoated paper
• Printing in black-and-white mode
• Room temperature
1.
In [Advanced Settings] for the custom paper in use, increase the value in [19:
Process Speed Setting] by one step.
• If it is presently set to [Low], change it to [Middle].
• If it is presently set to [Middle], change it to [High].
2.
Set [44: Fusing Heat Roller Temperature Adj] to "180°C".
3.
Print the image. Does it exhibit any fusing problem?
Yes
You cannot improve throughput under the present condition. Restore
the previous setting.
No
You can operate the machine using this setting.
To Next Page
Loading...
Need help?
General
