Solution:
You can lessen the problem by decreasing the paper feed speed of the decurler unit.
1. In the [Main Unit: Paper Feed/ Output] group on the [Adjustment Settings for Operators]
menu, check the present degree of decurling (Off, Small, or Large) in 0310: [Correct
Output Paper Curl].
2. Select [Machine: Paper Feed / Output] in [Advanced Settings] for the custom paper in
use, select 1351: [Motor Speed] and adjust the paper feed speed of the decurler unit.
• If the degree of decurling is set to "Correction Level: Off", reduce the value in [Decurler:
Correction Off] by 0.5%.
• If the degree of decurling is set to "Correction Level: Small", reduce the value in [Decurler:
Correction Weak] by 0.5%.
• If the degree of decurling is set to "Correction Level: Large", reduce the value in [Decurler:
Correction Strong] by 0.5%.
3. Print the image. Is the problem resolved?
Yes Finished!
No Keep decreasing the value by 0.5% until the problem is resolved.
If the problem persists even though the setting has reached its minimum value, contact your
service representative.
Scratches, Streaks, or Vertical Creases Appear on the Image
Cause:
The paper feed speed of the exit motor, switchback entrance, or switchback exit is too high or too low.
• To adjust the following settings, pre-register the type of paper in use as a custom paper. For details
about registering custom papers, see "Registering a Custom Paper", Preparation.
Solution:
<If scratches or streaks appear on the side 2 of the paper>
You can lessen the problem by decreasing the paper feed speed.
1. Select [Machine: Paper Feed / Output] in [Advanced Settings] for the custom paper in use,
select 1351: [Motor Speed] and adjust the paper feed speed for delivery.
Depending on the type of printing, specify one of the following:
Paper Feed Problems Affecting Image Quality
99
To Next Page
Loading...
Need help?
General
