2. Check the present value. Is it the upper limit?
Yes Go to Step 5.
No Go to the next step.
3. Increase the absolute value of the current by 5 A in [Image Transfer Output].
4. Print the image. Is the problem resolved?
Yes Finished!
No Increase the value by 5 A. If the problem persists even though you have increased
the value to the upper limit (150 A), go to the next step.
5. Do you mind if image density is low?
Yes Contact your service representative.
No Go to the next step.
6. Select [Machine: Image Quality] in [Advanced Settings] for the custom paper in use, select
1201: [Max Image Density].
7. Check the present value. Is it the lower limit?
Yes Contact your service representative.
No Decrease the value by 1 in [Max Image Density].
8. Print the image. Is the problem resolved?
Yes Finished!
No Repeat Steps 5 to 7. If the problem persists even though you have decreased the
value to the lower limit, contact your service representative.
Toner Scatter (3)
Parts of a line or character exhibit splatter. This may occur in a line or character that is 8 to 13 mm (0.3
to 0.5 inches) from the trailing edge and 20 mm (0.8 inches) or less from the left edge facing the paper
feed direction.
3. Troubleshooting Image Quality Problems
34
To Next Page
Loading...
Need help?
General
