• There is a tight curl on a delivered set of stapled sheets.
• Limp paper such as thin or recycled paper is used.
Output tray
Paper exit
Paper feed direction
Trailing edge
too near exit
CEZ593
Solution:
1. In the [Main Unit: Paper Feed/ Output] group on the [Adjustment Settings for Operators]
menu, set 0310: [Correct Output Paper Curl] to "U Curl Correction Level".
Select "Large" or "Small" to control the level of decurling as required.
2. Print the image. Is the problem resolved?
Yes Finished!
No Contact your service representative.
Sheets cannot be stapled properly
Cause:
When the sheets are fed to the staple unit inside the finisher, they may be overlaid, resulting in a
misalignment of 5 mm (0.2 inches) relative to each other after stapling.
When coated or other paper producing higher paper-to-paper friction is used, the paper edges are not
aligned properly, resulting in misaligned stapling.
This is likely to occur if:
• Coated or other paper producing higher paper-to-paper friction is used.
• Thin or other limp paper is used.
Finisher SR5090/Booklet Finisher SR5100
139
To Next Page
Loading...
Need help?
General
