No Go to the next step.
5. Set 0310: [Correct Output Paper Curl] to [U Curl Correction Level: Large].
6. Print the image. Has the problem been resolved?
Yes Finished!
No Go to the next step.
7. Is the sheet curled downward?
Yes Contact your service representative.
No Load the sheets the other way up, and then repeat the steps from Step 3.
The Machine Wrongly Detects That the Tray Is Full
Cause:
Depending on the paper size, the machine may detect that the shift tray has reached the maximum
number of sheets that can be stacked on it.
This may occur if paper with a width of 191-261 mm (7.6 - 10.4 inches) is being used.
Solution:
< Paper with a width of 191–261 mm (7.6 - 10.4 inches) is being used >
1. Load the sheets the other way up.
2. Print the image. Has the problem been resolved?
Yes Finished!
No Go to the next step.
To follow the steps below, attach the decurler unit.
3. In the [Main Unit: Paper Feed/ Output] group of the [Adjustment Settings for Operators]
menu, set 0310: [Correct Output Paper Curl] to [U Curl Correction Level: Off].
4. Print the image. Has the problem been resolved?
Yes Finished!
High Capacity Stacker
169
To Next Page
Loading...
Need help?
General
